3M 467MP Clear Adhesive Transfer Tape, 3" Width x 5yd Length (1 roll)

Brand:3M

3.6/5

€
42.20

Lamination to industrial foams for rotary die-cutting of small gaskets for industrial and electronics markets. Excellent resistance to harsh environments; this adhesive can withstand splashes of organic solvents, weak acids and bases and salt water, cleaning solutions, germicidals, disinfectants, oils, etc. In addition, it performs well after exposure to humidity and hot/cold cycles. Bonding metal nameplates and rating plates in the aerospace, medical and industrial equipment, automotive, appliance and electronic markets. Bonding graphic overlays for membrane switches and for bonding the complete switch to the equipment surface. High speed processing of parts in the medical, telecommunications and electronics markets (medical components, durable labels, flexible circuits).

Amount

Add to Cart Buy now

EAN: 0888519006368

Categories Industrial & Scientific, Adhesives, Sealants & Lubricants, Adhesive Tapes, Adhesive Transfer Tape,

Brand	3M
Color	Clear
Item model number	3-5-467MP
Manufacturer	TapeCase
Material	Metal
Number of Items	1
Product Dimensions	2 x 3 x 1.7 inches; 2.47 Ounces
Surface Recommendation	Metal

5 Star

4 Star

3 Star

2 Star

1 Star

Write your review

Your email will not be published. All mandatory fields are marked with^*

Your rating

Scritto da: Stickman

Phenomenal tape for high temp, hard to bond items. Just follow the rules.

I used this to bond aluminum (sheet/foil) to galvanized steel in a high heat application. (About 250F). It's been on for 7 years and still holding very, very well. NOTE: It's difficult to apply. You have to be patient and willing to work with it. When you unroll it and apply it to one side, make sure that side is ultra clean and press like hell! Make sure it's really really bonded. In fact we put many, many strips on, let them set for half and hour and then came and pulled the backing off. That gives the one side time to cure and get a really good bond to the metal. Then you pull off the backing paper and you then apply the other material. So far I have used this for polyethylene to aluminum, aluminum to galvanized steel, foam insulation to PVC/Vinyl, etc. It has always worked for me, but you do have to follow certain procedures and be patient.

Scritto da: Mary

Not what I was expecting.

I could have bought the wrong thing too, but I could not get the sticky part separated from the paper. This product is of no use to me, so I will be returning it.