HHIP 3900-4866 5/16" Square Head Standard Lathe Chuck Wrench 5/16" Head Size Standard

Brand:HHIP

3.5/5

€
39.38

Item Package Dimension: 1.5" L x 1.5" W x 4.0" H. For use on lathe chucks. Made of high quality tool steel. 5/16" Square Head Standard Lathe Chuck Wrench.

Amount

Add to Cart Buy now

EAN: 0769053026602

Categories Tools & Home Improvement, Power & Hand Tools, Hand Tools, Wrenches, Torque Wrenches,

Item Package Dimension: 1.5" L x 1.5" W x 4.0" H. For use on lathe chucks. Made of high quality tool steel. 5/16" Square Head Standard Lathe Chuck Wrench.

Brand	HHIP
Compatible Devices	Lathe
Included Components	Wrench
Material	Alloy Steel

5 Star

4 Star

3 Star

2 Star

1 Star

Write your review

Your email will not be published. All mandatory fields are marked with^*

Your rating

Scritto da: David Johnson

Sliding T-Handle works fine.

Happy with the seller. No problems and the wrench worked as it should.

Scritto da: tony salazar

Is perfect

good fit

Scritto da: eric c.

Needs corners radiused

Likes are . Sturdy made, long tee handle that slides for torque leverage. Dislike. Only one and that is corners of the square drive need to be radiused to allow the key to insert fully into the chuck. This radius is easy enough to do on a bench grinder.

Scritto da: joseph fusco jr

High Quality

Heavy for its size and well made. Great product.

Scritto da: Mcode 21

Good tool

I measured it wrong, but I got just what I ordered. Of course I found mine so I sent it back great response. Well done.

Scritto da: Amazon Customer

Lathe Chuck Key

Every chuck key I've ever used...drill chuck (Jacobs type) or lathe chuck (3 or 4 jaw) has been a 'T" type with the handle pressed or welded into the body. This key has a loose handle. I presume to give the user more leverage when tightening. I tried to use it but stopped in the middle of a job and brazed it into place. Otherwise, the material appears to be hard enough to resist wear and the square drive end is a nice fit with no tendency to slip out of my ancient and worn 3-jaw chuck.

Scritto da: John Rosenfelder

Fits my South Bend 9B

Fits my South Bend 9B

Scritto da: Chris Noe

Square corners wouldn't fit

Chuck hole was worn and the square corners wouldn't fit so I heated it red hot and tapped it into the chuck hole. The corners flattened and the square drive got fatter for a perfect fit. Retempered it in cold water. 100% PERFECT

Scritto da: John Brouwers

Five Stars

Great product and service