TurboClip 89280 Narrow Gap Universal Hidden Deck Fasteners, (1 Box of 800)

Brand:TurboClip

3.7/5

579.36

Insert the TurboClip Universal hidden deck clip into the groove of the deck board. Unlike regular deck clips, TurboClip Universal hidden deck clips come in sticks of 16, so you aren't continuously reaching for another clip at every joist. TurboClip Universal hidden deck clips come with preloaded, stainless steel screws, so you don't have to worry about dropping screws while lining up and placing each clip.

No units available
Cut your deck board installation time by up to 60-percent, saving you valuable hours and money. Simply insert the TurboClip into the side groove of your decking board, drive the preloaded screw through the TurboClip and into your deck support, then snap off the remaining TurboClip stick. Each deck clip on the TurboClip stick comes preloaded with a stainless steel screw. Includes: 800 clips, 50 sticks. Creates a 3/16-inch gap between deck boards; covers approximately 425 square feet.
Batteries Required? ‎No
Country of Origin ‎USA
Customer Reviews 4.6 4.6 out of 5 stars 18 ratings 4.6 out of 5 stars
Included Components ‎Hidden deck fasteners
Item model number ‎89280
Item Package Quantity ‎1
Item Weight ‎10.63 pounds
Manufacturer ‎TurboClip
Material ‎Glass Filled Nylon
Package Dimensions ‎12.72 x 9.65 x 7.28 inches
Part Number ‎89280

3.7

1 Review
5 Star
73
4 Star
15
3 Star
12
2 Star
0
1 Star
0

Write your review

Your email will not be published. All mandatory fields are marked with*

Scritto da: tallhapa
Great Concept
Just did 400sqft of decking with these and they really make life easier. Slip in to groove, screw in 90% of the way, twist to rip off the one you just put in, and move on. Why only screw in 90%? If you screw in 100% of the way, the side that isn't in a groove yet, because that board isn't there, angles down and getting the next board in is pretty much impossible. So to make it easier we only screwed the clip in part way before slipping the next board in, then we went back and screwed in the rest of the way. Yes a bit more work but if you set your drill correctly its hard to over-tighten as you race back through finishing them off. The gap is a bit large for my taste, but 3/16 is standard for all sorts of fastening systems and recommended by the manufacturer. We have a darker deck and so the black pretty much blends in, but if you focus you can see these things all over. I say this as if we had a light color deck I'm not sure what I would do. We used this on Fiberon composite for what its worth.

Related products

Discover our international network

We ship to 28 countries, over 200,000 products. Stay updated, subscribe to the newsletter.

Array